FOR SMARTER AND FASTER CURING OF ALL PRONAILS GELS
The ProNails SMART LIGHT has four individual timer buttons with built in smart LED intelligence. The timer buttons come in 30 and 60 seconds in either Full Start or in Soft Start function. The SOFT START function , allows you to control the power output of your lamp at the beginning of the curing process to reduce heat sensation on the nail. The FULL START function uses the full capacity of the lamp for optimal curing of colours and glosses.
All ProNails Base and Builder gels cure in 30 seconds SOFT START. The 30 sec SOFT START function will start at 40% capacity and will gradually increase to 100% as shown in the graph. For sensitive customers you can slow down the curing process to 60 seconds SOFT START instead: this will start the curing at a reduced capacity (of 20%) and will increase more slowly to 100%. The ProNails Smart Light is highly recommended with the use of 3-in-1 gels such as the MASTER and ONE for optimal speed and heat control.
SMARTER & FASTER CURING TIMES
30 SEC Soft start *
- BASE GELS
- FLEXI BUILDER GELS
- HARD BUILDER GELS
- 3-IN-1 GELS ( MASTER & ONE )
- CAMOUFLAGE GELS
- REPAIR GELS
- * 60 SEC SOFT FOR SENSITIVE CLIENTS
30 SEC FULL START
- BRUSH-ON GLOSS GELS (BOTTLE)
- SOPOLISH (BASE-COLOUR-SHINE)
- GELLAK COLOUR GELS
- FRENCH MANICURE GELS
60 SEC FULL START
- GLOSS GELS ( IN JAR )
NEW SMART LED TECHNOLOGY
Ceramic substrate 36W LED lights
12x 400 nm LED lights for perfect curing of LED gels
10x 365 nm LED lights for perfect curing of UV gels
HOW TO USE THE SMART LIGHT
Choose required curing time and curing capacity
Choose required curing times (30 Sec or 60 Sec) and curing capacities (SOFT or FULL) on top of the unit according to protocols.
Automatic ON/OFF : Place your hand inside the lamp to activate the sensors. Allow middle finger to follow the guidance tunnel to the end positioning point on the bottom plate. Position all fingers on the individual finger locations for perfect curing. The lamp will light up automatically as well as stop automatically after the chosen timer cycle of 30 sec or 60 sec is completed.
During curing, both timer button and logo will be lit. When operating in SOFT mode the timer button and logo will light up in turquoise blue. When operating in FULL mode the timer button and logo will light up in a deeper blue.
5- Finger curing
Apply 5 finger curing for base gels, colours and glosses. Make sure to place the fingers c
orrectly onto the individual finger positioning points.
4- Finger Curing
Apply 4+1 curing method for builder gels but always insert your full hand for 4 finger curing. When curing thumbs separately, use only the left and right thumb positioning points. Do not place the thumbs in the middle of the lamp as they will not get sufficient light for proper curing.
You can force the lamp on manually by pressing again of the required timer button. This button will stay on ( and by pass the sensors) during one timer cycle. To abort the curing early, press the timer button once.